Semi-Auto Insole Design and Ordering

Here we will walk through the process of ordering custom insole products and demonstrating the manual design steps inside the Shapshift3D Toolbox.

This video demonstrates the E2E order and design process with our 3/4 Manual Insole w/ Heel Aperture product

This video demonstrates the E2E order and design process with our 3/4 Manual Insole w/ Heel Lift product 

For more information regarding product variant options selected during the order process, please see below chart:

Name	Accepted Values	Description
Side	Left or Right	foot side of input scan
Scan Type	Direct or Foambox	Type of input scan
Metatarsal Depth	0 or higher	Choose if you want to rectify the depth of the scan in the metatarsal region. A value higher than 0 will dig into the scan in this region.
Raise Medial Arch	0 or higher	Choose if you want to rectify the depth of the scan in the medial arch region. A value higher than 0 will dig into the scan in this region.
Metatarsal Pad Positioning	2nd Meta, 3rd Meta or 4th Meta	Choose where you want to position the metatarsal pad. This defines where the metatarsal region rectification will be.
Metatarsal Pad Size	Small, Medium or Large	Choose between three standard sizes for the metatarsal pad.
Metatarsal Pad Shape	Tear or Triangle	Choose the shape of the metatarsal pad.
Varum Correction Angle	0 or higher	Choose the level of correction of the varum (in degrees).
Varum Correction Type	Varus or Valgus	Choose the type of correction to execute.
Foot Area	ForeFoot, Heel, Both	Choose in which area of the foot to apply the correction.
Intrinsic Posting (degrees or mm)	0 or higher	Choose the value for the intrinsic posting. The intrinsic posting value will define the final height of the printed insole's heel puck. The intrinsic posting should be set to 0 if: The heel puck feature is disabled
Heel Cup Height	Positive number	Sets the height of the insole’s heel cup.
Overall Insole Thickness	3mm to 6mm	Sets the overall thickness of the insole
Additional Arch Thickness	0 mm, 0.5mm, 1mm, 1.5mm or 2mm	Adds an additional thickness of the chosen value in the medial arch region of the insole.
Heel Puck	Enabled or disabled	Choose if you want to add a heel puck to the insole. It should be disabled if: 1. Intrinsic posting and extrinsic posting were set to 0. 2. The heel hole feature is enabled.
Heel Hole	Enabled or disabled	Choose if you want to add a hole at the heel of the insole. This should be desabled if : The heel puck feature is enabled.